Search
Now showing items 21-30 of 71
Nanocrystalline Nickel Manganite Synthesis by Sol-Gel Combustion for Flexible Temperature Sensors
(Institute of Electrical and Electronics Engineers Inc., 2020)
Nanocrystalline nickel manganite (NiMn2O4) was obtained by sol-gel combustion using glycine as fuel, followed by calcination at 800°C. X-ray diffraction (XRD) analysis confirmed the formation of a pure cubic spinel structure ...
A scaling approach to size effect modeling of J(c) CDF for 20MnMoNi55 reactor steel in transition temperature region
(Elsevier, 2022)
Ever since the 1980s there is a sustained interest in the size effect, as one of the most pronounced consequences of fracture mechanics. In the present study, the investigation of the size effect is focused on estimation ...
Application of Nanocrystalline Pseudobrookite (Fe2TiO5) Thick Films for Humidity Sensing
(IEEE Computer Society, 2018)
Pseudobrookite nanocrystalline thick films were screen printed on alumina substrate with small interdigitated PdAg electrodes (width 6 mm, length 12 mm, electrode spacing 0.2 mm) and fired at 600 degrees C for 30 minutes. ...
Molecular-dynamics simulations of the nanoscale Taylor test under extreme loading conditions
(SAGE Publications, 2016)
A series of molecular-dynamics simulations of the classic Taylor impact test is performed by using a flat-ended monocrystalline nanoscale projectile made of the Lennard-Jones two-dimensional solid. The nanoprojectile ...
Damage-fragmentation transition: Size effect and scaling behavior for impact fragmentation of slender projectiles
(SAGE Publications, 2018)
The focus of the present article is on the size effect of a transition region from the damaged to the fragmented phase in impact-induced breakup of a slender projectile. Molecular dynamics simulations of the classic ballistic ...
A Note on Short-time Response of Two-dimensional Lattices during Dynamic Loading
(SAGE Publications, 2008)
The disordered 2D lattices are used extensively to study damage
evolution and fracture of inhomogeneous or multi-phase systems. The present note
addresses their initial elastic response during dynamic loading. Namely, a ...
Titanium doped yttrium manganite: improvement of microstructural properties and peculiarities of multiferroic properties
(Springer, 2022)
Yttrium manganite, YMnO3, was doped with different concentrations of titanium (x = 0, 0.04, 0.08, 0.10, 0.15, 0.20) in order to improve the microstructural and multiferroic properties. The powders were prepared using sol-gel ...
Synthesis and characterization of Pt nanocatalyst on Ru0.7Ti0.3O2 support as a cathode for fuel cells application
(Elsevier Science Sa, Lausanne, 2015)
Ruthenium oxide/titanium oxide, with a Ru:Ti atomic ratio of 7:3 was synthesized by modified sol-gel procedure and used as a support for platinum nanocatalyst for oxygen reduction reaction. The synthesized materials were ...
Rapid point-of-need detection of bacteria and their toxins in food using gold nanoparticles
(Wiley, Hoboken, 2021)
Biosensors need to meet the rising food industry demand for sensitive, selective, safe, and fast food safety quality control. Disposable colorimetric sensors based on gold nanoparticles (AuNPs) and localized surface plasmon ...
The Krajcinovic approach to model size dependent fracture in quasi-brittle solids
(Elsevier, 2014)
The failure in “quasibrittle” microstructural systems, occurring with no early warning, is a debated problem of great practical importance for the structural engineering community. Available models do not fully account for ...