Претраживање
Приказ резултата 11-20 од 44
Influence of mechanical activation on sphene based ceramic material synthesis
(Elsevier Sci Ltd, Oxford, 2013)
Sphene (CaTiSiO5), a calcium titanosilicate ceramic has been prepared from a powder mixture of CaCO3, TiO2 and SiO2 using vibromilling for homogenization and activation of precursors. The mechanochemical process initially ...
High-voltage electrophoretic deposition of preferentially oriented films from multiferroic YMn2O5 nanopowders
(Elsevier Sci Ltd, Oxford, 2013)
Processing of the YMn2O5 powder is very challenging, since it decomposes to YMnO3 and Mn3O4 at temperatures close to 1180 degrees C, while samples consolidation commonly demands high temperatures. The main goal of this ...
Physical-mechanical and microstructural properties of alkali-activated fly ash-blast furnace slag blends
(Elsevier Sci Ltd, Oxford, 2015)
This paper investigated physical mechanical and microstructural properties of alkali-activated binders based on blends of fly ash (FA) and blast furnace slag (BFS). FA BFS blends were alkali-activated with sodium silicate ...
Dielectric and ferroelectric properties of BST ceramics obtained by a hydrothermally assisted complex polymerization method
(Elsevier Sci Ltd, Oxford, 2015)
Ba0.8Sr0.2TiO3 (BST) powder, obtained by a hydrothermal treatment of precursor solution previously prepared by a complex polymerization method (HT-CPM), was uniaxially pressed and sintered at 1280 degrees C for 1-32 h. The ...
Structural, electrical and magnetic properties of nickel manganite obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2014)
Structural, electrical and magnetic properties of nickel manganite ceramics obtained by sintering fine powders prepared by a complex polymerization method are given in this work. The phase composition of the synthesized ...
Ex-situ sensitization of ordered TiO2 nanotubes with CdS quantum dots
(Elsevier Sci Ltd, Oxford, 2015)
Ordered titania nanotubes (pore diameter approximate to 90 nm and wall thickness approximate to 10 nm) were obtained by the anodization technique and used for the ex-situ deposition of cadmium sulfide quantum dots (CdS ...
Enhanced stability in CO2 of Ta doped BaCe0.9Y0.1O3-delta electrolyte for intermediate temperature SOFCs
(Elsevier Sci Ltd, Oxford, 2013)
The influence of Ta concentration on the stability of BaCe(0.9-)xTa(x)Y(0.1)O(3-delta) (where x=0.01, 0.03 and 0.05) powders and sintered samples in CO2, their microstructure and electrical properties were investigated. ...
Antiferromagnetism and heat capacity of NaCo2-xCuxO4 ceramics
(Elsevier Sci Ltd, Oxford, 2017)
Polycrystalline samples of NaCo2-xCuxO4 (x=0, 0.01, 0.03 and 0.05) were synthesized in two different ways: 1) by a mechanochemically assisted solid-state reaction method (MASSR) and 2) by a citric acid complex method (CAC). ...
Lead-free BaBi4Ti4O15 ceramics: Effect of synthesis methods on phase formation and electrical properties
(Elsevier Sci Ltd, Oxford, 2015)
The processing of ferroelectric BaBi4Ti4O15 (BBT) ceramics from powders prepared by conventional solid state reaction (SSR) and mechanochemical activation (MA) has been investigated. It was shown that MA synthesis reduces ...
Effect of preparation route on the microstructure and electrical conductivity of co-doped ceria
(Elsevier Sci Ltd, Oxford, 2013)
Dense Ce0.8Sm0.1Gd0.1O2-delta electrolytes were fabricated by sintering of CeO2 solid solutions which were prepared from metal nitrates and NaOH using self propagating room temperature synthesis (SPRT). Three different ...