Претраживање
Приказ резултата 1-10 од 31
Improvement of barium titanate properties induced by attrition milling
(Elsevier Sci Ltd, Oxford, 2012)
Barium titanate powder was prepared by soft chemical process from polymeric precursors (modified Pechini process). The synthesized barium titanate (BT) powder was nanosized and the factor of agglomeration (F-agg) pointed ...
Influence of mechanical activation on sphene based ceramic material synthesis
(Elsevier Sci Ltd, Oxford, 2013)
Sphene (CaTiSiO5), a calcium titanosilicate ceramic has been prepared from a powder mixture of CaCO3, TiO2 and SiO2 using vibromilling for homogenization and activation of precursors. The mechanochemical process initially ...
High-voltage electrophoretic deposition of preferentially oriented films from multiferroic YMn2O5 nanopowders
(Elsevier Sci Ltd, Oxford, 2013)
Processing of the YMn2O5 powder is very challenging, since it decomposes to YMnO3 and Mn3O4 at temperatures close to 1180 degrees C, while samples consolidation commonly demands high temperatures. The main goal of this ...
Hydrothermally assisted synthesis of YMnO3
(Elsevier Sci Ltd, Oxford, 2015)
In this work single phase hexagonal YMnO3 powders were prepared starting from Y(CH3COO)(3)center dot xH(2)O, Mn(CH3COO)(2)center dot 4H(2)O, KMnO4 and KOH using methods of conventional (280 degrees C for 6 h) or microwave ...
Structural, electrical and magnetic properties of nickel manganite obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2014)
Structural, electrical and magnetic properties of nickel manganite ceramics obtained by sintering fine powders prepared by a complex polymerization method are given in this work. The phase composition of the synthesized ...
Enhanced stability in CO2 of Ta doped BaCe0.9Y0.1O3-delta electrolyte for intermediate temperature SOFCs
(Elsevier Sci Ltd, Oxford, 2013)
The influence of Ta concentration on the stability of BaCe(0.9-)xTa(x)Y(0.1)O(3-delta) (where x=0.01, 0.03 and 0.05) powders and sintered samples in CO2, their microstructure and electrical properties were investigated. ...
Synthesis and characterization of tungsten carbide fine powders
(Elsevier Sci Ltd, Oxford, 2015)
Fine tungsten carbide (WC) powder was prepared by solid state reaction between tungsten powder (W) and activated carbon cloth as a new carbon (C) source. The effect of temperature and time of heat treatment as well as the ...
Ex-situ sensitization of ordered TiO2 nanotubes with CdS quantum dots
(Elsevier Sci Ltd, Oxford, 2015)
Ordered titania nanotubes (pore diameter approximate to 90 nm and wall thickness approximate to 10 nm) were obtained by the anodization technique and used for the ex-situ deposition of cadmium sulfide quantum dots (CdS ...
Physical-mechanical and microstructural properties of alkali-activated fly ash-blast furnace slag blends
(Elsevier Sci Ltd, Oxford, 2015)
This paper investigated physical mechanical and microstructural properties of alkali-activated binders based on blends of fly ash (FA) and blast furnace slag (BFS). FA BFS blends were alkali-activated with sodium silicate ...
Lead immobilization by geopolymers based on mechanically activated fly ash
(Elsevier Sci Ltd, Oxford, 2014)
In this paper, the effectiveness of geopolymers based on initial and mechanically activated fly ash in immobilization of lead was investigated. Fly ash (FA) was firstly mechanically and then alkali activated at room ...