Pretraživanje
Prikaz rezultata 1-10 od 13
Structure study of nanosized La- and Sb-doped BaTiO3
(Elsevier Science Sa, Lausanne, 2010)
Lanthanum and antimony doped barium titanate powders were prepared by polymeric precursors method through Pechini process. Obtained powder was pressed into pellet and sintering was performed at 1300 degrees C for 8 h. The ...
Electrodeposition of Zn-Mn alloys at high current densities from chloride electrolyte
(Springer, New York, 2013)
The Zn-Mn alloy electrodeposition on a steel electrode in chloride electrolyte was investigated with the aim of obtaining deposits with as high as possible Mn percent. It was found that the deposition current density and ...
Sintering and electrical properties of Ce1-xBixO2-delta solid solution
(Elsevier Science Sa, Lausanne, 2014)
Solid solution Ce1-xBixO2-delta nanopowders with the composition of x = 0.1-0.5 were synthesized by using Self Propagating Room Temperature procedure (SPRT). The results obtained by XRPD show that synthesized samples were ...
Physical-mechanical and microstructural properties of alkali-activated fly ash-blast furnace slag blends
(Elsevier Sci Ltd, Oxford, 2015)
This paper investigated physical mechanical and microstructural properties of alkali-activated binders based on blends of fly ash (FA) and blast furnace slag (BFS). FA BFS blends were alkali-activated with sodium silicate ...
Dielectric and relaxor behavior of BaBi4Ti4O15 ceramics
(Elsevier Science Sa, Lausanne, 2010)
Barium bismuth titanate BaBi4Ti4O15 (BBiT) ceramics have been prepared using non-conventional solid-state reaction route based on mechanochemical synthesis during intensive milling. The X-ray diffraction method was used ...
Electrical properties of lanthanum doped barium titanate ceramics
(Elsevier Science Inc, New York, 2011)
Pure and lanthanum doped barium titanate (BT) ceramics were prepared by sintering pellets at 1300 degrees C for 8 h, obtained from nanopowders synthesized by the polymeric precursor method. XRD results showed formation of ...
Optimization of electrolytic process of formation of open and porous copper electrodes by the pulsating current (PC) regime
(Elsevier Science Sa, Lausanne, 2011)
Optimization of process of formation of open and porous copper electrodes, denoted as the honeycomb-like ones, by the regime of pulsating current (PC) is considered. The square-waves PC were consisted of the same amplitude ...
Effect of preparation route on the microstructure and electrical conductivity of co-doped ceria
(Elsevier Sci Ltd, Oxford, 2013)
Dense Ce0.8Sm0.1Gd0.1O2-delta electrolytes were fabricated by sintering of CeO2 solid solutions which were prepared from metal nitrates and NaOH using self propagating room temperature synthesis (SPRT). Three different ...
Electrical properties of antimony doped barium titanate ceramics
(Pergamon-Elsevier Science Ltd, Oxford, 2013)
Antimony doped barium titanate powders were synthesized by polymeric precursors method based on modified Pechini process. Obtained powders were pressed and sintered at 1300 degrees C for 8 h. XRD analysis showed the formation ...
Structural and electrical properties of BaCe(0.9)Ee(0.1)O(2.95) electrolyte for IT-SOFCs
(Pergamon-Elsevier Science Ltd, Oxford, 2015)
BaCe(0.9)Ee(0.1)O(2.95) (BCE) nanopowder was synthesized by citric-nitric autocombustion method. Rietveld refinement analysis showed that unit cell volume was slightly larger compared with the most known BaCe0.9Y0.1O2.95, ...