Претраживање
Приказ резултата 301-310 од 320
Electrical properties of antimony doped barium titanate ceramics
(Pergamon-Elsevier Science Ltd, Oxford, 2013)
Antimony doped barium titanate powders were synthesized by polymeric precursors method based on modified Pechini process. Obtained powders were pressed and sintered at 1300 degrees C for 8 h. XRD analysis showed the formation ...
KIT-5-Assisted Synthesis of Mesoporous SnO2 for High-Performance Humidity Sensors with a Swift Response/Recovery Speed
(MDPI, 2023)
Developing highly efficient semiconductor metal oxide (SMOX) sensors capable of accurate and fast responses to environmental humidity is still a challenging task. In addition to a not so pronounced sensitivity to relative ...
Exploring the impact of calcination parameters on the crystal structure, morphology, and optical properties of electrospun Fe2TiO5 nanofibers
(Royal Soc Chemistry, Cambridge, 2021)
Nanostructured Fe2TiO5 (pseudobrookite), a mixed metal oxide material holds significant promise for utilization in energy and environmental applications. However, its full application is still hindered due to the difficulty ...
Fly ash as the potential raw mixture component for portland cement clinker synthesis
(Springer, Dordrecht, 2009)
This paper presents the results of investigation of properties of fly ash from four major thermal power plants in Serbia. Chemical, mineralogical and thermal characterization of fly ash has been performed in order to ...
Properties of MnZn ferrites prepared by powder injection molding technology
(Elsevier Science Bv, Amsterdam, 2010)
In this work, manganese zinc ferrite components were manufactured by powder injection molding-PIM technology. A fine powder consisting of Mn1-xZnxFe2O4 with small addition of hematite alpha-Fe2O3 as used in mass ferrite ...
Fabrication of BaTiO3-based thin film heterostructures with ring electrodes by low cost deposition techniques
(Springer, Dordrecht, 2019)
In this paper the fabrication of BaTiO3-based thin film heterostructures with ring silver electrodes by low cost deposition techniques was investigated. BaTiO3, Ba1-xSrxTiO3 (x = 0.1, 0.2, 0.3, 0.4) and BaTi1-xZrxO3 (x = ...
Nucleation and early stages of growth of lead onto copper electrodes from dilute electrolytes
(Elsevier Science Bv, Amsterdam, 2016)
The processes of nucleation and growth of lead from the dilute electrolytes on copper substrates were investigated by chronoamperometry and by scanning electron microscopic (SEM) analysis of the deposits obtained in the ...
Tailoring the ferroelectric and magnetic properties of Bi5Ti3FeO15 ceramics by doping with Co and Y
(Elsevier Masson s.r.l., 2022)
The ferroelectric and magnetic properties of four-layered Aurivillius Bi5Ti3FeO15 (BFT) compounds via partial substitution of Bi3+ with Y3+ and Fe3+ with Co2+ (according to formula: Bi5-xYxTi3FeO15, x = 0.1, 0.2, 0.3; ...
Application of pulsating overpotential regime on the formation of copper deposits in the range of hydrogen co-deposition
(Springer, New York, 2010)
Electrodeposition of copper by pulsating overpotential (PO) regime in the range of hydrogen co-deposition was examined by scanning electron microscopy. It was found that the increase of the pause-to-pulse ratio produced a ...
Z-cells and oogonia/oocytes in the advanced process of autophagy are the dominant altered cells in the ovaries of hypothyroid newborn rats
(Faculty of Veterinary Medicine, University of Belgrade, Serbia, 2017)
Induced prenatal hypothyroidism in rat pups leads to accelerated primordial follicle
assembly and premature follicular atresia with ovary failure. This work investigates the
infl uence of maternal hypothyroidism induced ...