Search
Now showing items 1-10 of 707
Parallel analysis of axial pressing, casting and PIM as routes for production of alnico8
(European Powder Metallurgy Association (EPMA), 2010)
Samples of Alnico8 were prepared from the same starting powder by pressing, casting and powder injection moulding (PIM), respectively, and characterized by SEM and thermal analysis-DTA/TGA. Optimization of the sintering ...
Characterization of the structure and magnetic properties of Fe49Co2V made by the powder metal injection molding route
(Advances in Powder Metallurgy and Particulate Materials - 2010, Proceedings of the 2010 Internationa, 2010)
The semi-hard magnetic alloy Fe49Co2V is widely used in electronics and automation. Many of these parts are complex ones which can be produced with significant advantages by the PIM technology. In this work the feedstock ...
Characterization of ferrite surface mount bead using S-parameters
(SIISY 2010 - 8th IEEE International Symposium on Intelligent Systems and Informatics, 2010)
In this paper, characterization of ferrite surface mount bead based on S-parameters measurement, using vector network analyzer E5071B and specially developed PCB test fixture, are presented. The validation of characterization ...
Design of RFID antenna in ink-jet printing technology
(IEEE, 2012)
In this paper design of 125 kHz RFID antenna is presented. The optimization and improvement of electrical characteristics, including inductance and Q-factor, is also discussed. Designed RFID antenna is part of the ID card, ...
MRI brain tumors images by using independent component analysis
(SISY 2011 - 9th International Symposium on Intelligent Systems and Informatics, Proceedings, 2011)
The magnetic properties of nuclei have significant applications in medical imaging. These applications are possible because the relaxation properties and the resonance frequency for a nucleus depend upon its environment. ...
Modeling of the heat loss in a thermal sensor for water made of NTC thick film segmented thermistors
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
NTC thick film segmented thermistors were realized by screen printing of a low resistivity paste and conductive PdAg paste printed for electrodes. Two thick film thermistors as thermal sensors were placed in plastic tube ...
Trends of Dithiocarbamate Residues in Raspberries in the Republic of Serbia over the Period 2007/2010
(Int Soc Horticultural Science, Leuven 1, 2012)
Dithiocarbamates (DTC) are among the most commonly used in the world. In the Republic of Serbia almost 300 active substances are registered including five dithiocarbamate fungicides (ziram, mancozeb, metiram, propineb and ...
Comparison of Resistive and Capacitive Strain Gauge Sensors Printed on Polyimide Substrate Using Ink-Jet Printing Technology
(Institute of Electrical and Electronics Engineers Inc., 2014)
In this paper we compared a resistive and capacitive strain gauge in terms of sensitivity and material cost, both printed with deposition material printer using silver nanoparticle ink on a flexible polyimide substrate. ...
Application for Fast Determination of Inductor's Electrical Characteristics from S-parameters
(Institute of Electrical and Electronics Engineers Inc., 2014)
This paper presents an application "IndCalc" for calculation of surface-mounted devices (SMD) inductor parameters, extracted from measured S-parameters. It simplifies characterization and provides reliable procedure for ...
Fuzzy logic point of view applied to diseases caused by dynamic mutations
(12th IEEE International Symposium on Computational Intelligence and Informatics, CINTI 2011 - Procee, 2011)
For the first time, this paper tries to explain the origins of diseases caused by unstable DNA repeats, known as dynamic mutations. It is common to find fairly simplified correlation between the number of DNA repeats and ...