Претраживање
Приказ резултата 1-10 од 15
The influence of tribophysical activation on non-isothermal sintering of BaTiO3 ceramics
(Trans Tech Publications Ltd, Durnten-Zurich, 2006)
In this paper the influence of tribophysical activation on non-isothermal sintering of barium titanate has been investigated. BaTiO3 Powders were tribophysically activated in a planetary ball mill for 0, 60 and 120 min., ...
Correlation between densification rate and microstructure evolution of mechanically activated BaTiO3
(Taylor & Francis Ltd, Abingdon, 2005)
Increasing demands on the quality of electronic ceramics requires a well-controlled correlation between particle morphology and processing conditions. Since mechanical activation is one of the methods for modification of ...
Analysis of isothermal sintering of zinc-titanate doped with MgO
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2007)
The aim of this work was analysis of isothermal sintering of zinc titanate ceramics doped with MgO obtained by mechanical activation. Mixtures of ZnO, TiO2 and MgO (0, 1.25 and 2.5%) were mechanically activated 15 minutes ...
Investigation of zinc stannate synthesis using photoacoustic spectroscopy
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2007)
Mixtures of ZnO and SnO2 powders, with molar ratio of 2:1, were mechanically activated for 40, 80 and 160 minutes in a planetary ball mill. The resulting powders were compacted into pellets and non-isothermally sintered ...
Influence of Bi2O3 on microstructure and electrical properties of ZnO-SnO2 ceramics
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2007)
The effects of small amounts (0.5; 1.0 and 1.5 mol. %) of bismuth oxide on the microstructure and electrical properties of ZnO-SnO2 ceramics have been studied. Starting powders of ZnO and SnO2 were mixed in the molar ratio ...
Microstructural evolution and electric properties of mechanically activated BaTiO3 ceramics
(Elsevier Sci Ltd, Oxford, 2007)
Ceramic materials with a perovskite related structures such as non-doped and doped barium titanate ceramics are attracting much interest for their application as capacitor dielectrics, resistors, thermal sensors, etc. Since ...
Thermal diffusivity of sintered 12CaO x 7Al(2)O(3)
(Springer Heidelberg, Heidelberg, 2008)
The thermal diffusivity and free carrier diffusion coefficient of 12CaO x 7 Al2O3 ( C12A7) sintered for different times in air or hydrogen followed by treatment with UV light were determined from photoacoustic phase and ...
Far infrared properties of sintered NiO
(Elsevier Sci Ltd, Oxford, 2007)
Far infrared reflection spectra of NiO polycrystals sintered at 1100 degrees C for various times (30-240 min) were measured at room temperature using a FTIR Spectrometer-Brucker 113V. The measured spectra depended on the ...
Structural analysis of Zn2TiO4 doped with mgo
(Springer New York LLC, 2009)
The starting mixtures of ZnO, TiO2, and MgO (0, 1.25, and 2.5 wt.%) powders are mechanically activated in a high-energy planetary mill for 15 min and then sintered between 800 and 1100 degrees C for 2 h. The influence of ...
Far infrared properties of sintered Pb0.9Sn0.1Te doped with palladium
(Springer, New York, 2009)
Far infrared reflectivity spectra of sintered Pb0.9Sn0.1Te doped with 0.2 and 2 at.% Pd are measured. The experimental results are analyzed using a fitting procedure based on a modified plasmon-phonon interaction model. ...