Search
Now showing items 11-20 of 1175
A Characterization of Ceramic SMD Inductors for PCB Applications
(IEEE, New York, 2009)
In this paper, a measurement technique, characterization and parameters extraction of SMD inductors for PCB applications are presented. These components, manufactured by Fair-Rite, are measured and characterized using a ...
Novel uniaxial anemometer containing NTC thick film segmented thermistors
(IEEE, New York, 2008)
A novel uniaxial anemometer was created using a NTC thick film segmented therinistor to measure wind speed and direction. The anemometer operated on the principle of heat loss caused by the air volume flow and air speed. ...
A detailed XRD and FTIR analysis of Bi2O3 doped ZnO-SnO2 ceramics
(A Global Road Map for Ceramic Materials and Technologies: Forecasting the Future of Ceramics, Intern, 2008)
ZnO-SnO2 ceramics were prepared with a traditional powder mixed oxide route by mixing starting powders of ZnO and SnO2 in the molar ratio 2:1 and adding small amounts (0.5; 1.0; and 1.5 molar%) of Bi 2O3. These mixtures ...
Influence of Processing Method on Dielectric Properties of BaBi4Ti4O15 Ceramics
(COST MPO9O4: Single- and multiphase ferroics and multiferroies with restricted geometries (SIMUFER) Closing Conference and Final Management Committee Meeting, CNR-lENl: Institute for Energetics and lnterphases, Genoa, ltaly 30th January -'1st February, 2014, 2014)
Bismuth layer-structured ferroelectrics (BLSF), first described by Aurivillius, have attracted much
attention for their application in non-volatile random access memory and high temperature piezoelectric
devices. BaBi4Ti4O15 ...
Asymmetry of Cardiac Interbeat Intervals in Heart Failure
(Institute of Electrical and Electronics Engineers Inc., 2020)
Heart rate (HR) asymmetry is a dynamic phenomenon related to the interplay of dominant regulatory mechanisms of cardiovascular system which operate over different scales of observation. The aim of this work is to examine ...
Design and Modelling of 3D Printed Capacitive Displacement Sensor
(IEEE Computer Society, 2021)
The aim of the work is the realization and modelling of a simple capacitive displacement sensor with the use of 3D printing technology and polylactic acid (PLA) material. The sensor consists of three 3D printed PLA parts: ...
Nanocrystalline Nickel Manganite Synthesis by Sol-Gel Combustion for Flexible Temperature Sensors
(Institute of Electrical and Electronics Engineers Inc., 2020)
Nanocrystalline nickel manganite (NiMn2O4) was obtained by sol-gel combustion using glycine as fuel, followed by calcination at 800°C. X-ray diffraction (XRD) analysis confirmed the formation of a pure cubic spinel structure ...
A comparison of major taste- and health-related compounds among newly released Italian strawberry cultivars
(Int Soc Horticultural Science, Leuven 1, 2021)
Strawberry (Fragaria x ananassa Duch.) is one of the most popular edible fruit worldwide of which consumption constantly increases with the development of new cultivars available at almost all season. Besides being delicious, ...
Impact of Microstructure on Humidity Influence on Complex Impedance of Iron Manganite
(IEEE Computer Society, 2020)
This work deals with our continued research of oxide materials for potential application in gas/humidity sensing. We have made thick film samples using iron manganite powder synthesized by a so/-gel combustion method with ...
An Overview of Oxide Materials for Gas Sensors
(Institute of Electrical and Electronics Engineers Inc., 2020)
This paper presents an overview of oxide materials applied for gas sensors. This category of materials has been extensively investigated and applied in gas sensors, due to their ease of fabrication, low cost, sensitivity ...