Претраживање
Приказ резултата 11-20 од 26
Hydrothermally assisted synthesis of YMnO3
(Elsevier Sci Ltd, Oxford, 2015)
In this work single phase hexagonal YMnO3 powders were prepared starting from Y(CH3COO)(3)center dot xH(2)O, Mn(CH3COO)(2)center dot 4H(2)O, KMnO4 and KOH using methods of conventional (280 degrees C for 6 h) or microwave ...
Structure and properties of chemically synthesized BiFeO3. Influence of fuel and complexing agent
(Elsevier Sci Ltd, Oxford, 2015)
Perovskite, single multiferroic bismuth ferrite was prepared by two chemical methods: auto-combustion and soft chemical route. Influence of different fuels and complexing agents and thermal treatment on purity of bismuth ...
Synthesis and characterization of tungsten carbide fine powders
(Elsevier Sci Ltd, Oxford, 2015)
Fine tungsten carbide (WC) powder was prepared by solid state reaction between tungsten powder (W) and activated carbon cloth as a new carbon (C) source. The effect of temperature and time of heat treatment as well as the ...
Dielectric and magnetic properties of BaTiO3-NiFe2O4 multiferroic composites
(Elsevier Sci Ltd, Oxford, 2014)
Multiferroic composites with the general formula x BaTiO3-(1-x) NiFe2O4 (x=0.5, 0.7, 0.8) were prepared by mixing chemically obtained nickel ferrite and barium titanate powders. Optimum processing parameters for a reduction ...
Antimony doping effect on barium titanate structure and electrical properties
(Elsevier Sci Ltd, Oxford, 2011)
Nanopowders of pure and antimony doped barium titanate (BaTiO3-BT) were synthesized by polymeric precursors method based on Pechini process. Obtained powders were pressed and sintered at 1300 degrees C for 8 h. XRD analysis ...
Structural and electrical properties of sintered Fe2O3/TiO2 nanopowder mixtures
(Elsevier Sci Ltd, Oxford, 2014)
Starting nanopowders of TiO2 (anatase 99.7%) and alpha-Fe2O3 (hematite) were mixed in the weight ratios 60:40 and 40:60. Green samples were sintered in the temperature range 750-1250 degrees C in air. Structural, morphological ...
Properties of lanthanum doped BaTiO3 produced from nanopowders
(Elsevier Sci Ltd, Oxford, 2010)
Pure and barium titanate (BT) powders doped with different lanthanum concentration were prepared by the polymeric precursor method (Pechini process) which was carried out as a three-stage process from organometallic ...
Improvement of barium titanate properties induced by attrition milling
(Elsevier Sci Ltd, Oxford, 2012)
Barium titanate powder was prepared by soft chemical process from polymeric precursors (modified Pechini process). The synthesized barium titanate (BT) powder was nanosized and the factor of agglomeration (F-agg) pointed ...
Structural, electrical and magnetic properties of nickel manganite obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2014)
Structural, electrical and magnetic properties of nickel manganite ceramics obtained by sintering fine powders prepared by a complex polymerization method are given in this work. The phase composition of the synthesized ...
Enhanced stability in CO2 of Ta doped BaCe0.9Y0.1O3-delta electrolyte for intermediate temperature SOFCs
(Elsevier Sci Ltd, Oxford, 2013)
The influence of Ta concentration on the stability of BaCe(0.9-)xTa(x)Y(0.1)O(3-delta) (where x=0.01, 0.03 and 0.05) powders and sintered samples in CO2, their microstructure and electrical properties were investigated. ...