Претраживање
Приказ резултата 1-10 од 17
Far infrared properties of sintered NiO
(Elsevier Sci Ltd, Oxford, 2007)
Far infrared reflection spectra of NiO polycrystals sintered at 1100 degrees C for various times (30-240 min) were measured at room temperature using a FTIR Spectrometer-Brucker 113V. The measured spectra depended on the ...
Strontium titanate films prepared by spray pyrolysis
(Elsevier Sci Ltd, Oxford, 2004)
Strontium titanate thin films were prepared by spray pyrolysis technique. Deposition parameters, such as solution concentration, time and temperature of deposition, and flow rate of carrier gas were optimized to obtain ...
Screen printed PLZT thick films prepared from nanopowders
(Elsevier Sci Ltd, Oxford, 2007)
The gap between the bulk materials and thin films can be filled with thick films suitably designed and appropriate processed. Thick films of complex system like lead-lanthanum-zirconium titanate (PLZT) is difficult to ...
Microstructural evolution and electric properties of mechanically activated BaTiO3 ceramics
(Elsevier Sci Ltd, Oxford, 2007)
Ceramic materials with a perovskite related structures such as non-doped and doped barium titanate ceramics are attracting much interest for their application as capacitor dielectrics, resistors, thermal sensors, etc. Since ...
Optimization of processing parameters for preparation of LaNiO3 thin films from the citrate precursors
(Elsevier Sci Ltd, Oxford, 2007)
Lanthanum nickel oxide (LaNiO3) is an electrically conductive ceramics, which has a potential use as electrode for ferroelectric thin films, multilayer actuators and many other electronic devices. In this work, LaNiO3 thin ...
ZnO varistors with reduced amount of additives prepared by direct mixing of constituent phases
(Elsevier Sci Ltd, Oxford, 2007)
The aim of this work was to reduce number of additives using new method of preparation, refered as "direct mixing of the constituent phases". The method is based on sintering of a mixture of constituent phases with the ...
Investigation on possibility of mechanochemical synthesis of CaTiO3 from different precursors
(Elsevier Sci Ltd, Oxford, 2007)
Recently, mechanochemical synthesis was widely used in preparation of perovskite type of materials, such as BaTiO3, PbTiO3, PZT, etc. In this work, the possibility of mechanochemical synthesis of CaTiO3 from different ...
Microstructural investigation of the PZT films prepared from the suspension of nanocrystalline powders
(Elsevier Sci Ltd, Oxford, 2004)
PZT thin films of composition Pb(Zr0.52Ti0.48)O-3 were prepared by a novel method from the suspension of nanocrystalline PZT powders. The powders were obtained by mechanochemical synthesis. Films were deposited on silicon ...
Nonlinear properties and stability of SnO2 varistors prepared by evaporation and decomposition of suspensions
(Elsevier Sci Ltd, Oxford, 2005)
SnO2 varistors doped with CoO, Cr2O3 and Nb2O5 were prepared by evaporation and decomposition of suspensions. The composition of the varistors was optimized to improve electrical properties, such as nonlinearity, leakage ...
Far infrared reflection spectroscopy of Zn2SnO4 ceramics obtained by sintering mechanically activated ZnO-SnO2 powder mixtures
(Elsevier Sci Ltd, Oxford, 2007)
A mixture of starting ZnO and SnO2 powders (molar ratio 2: 1) were mechanically activated for 10, 40, 80 and 160 min in a planetary ball mill and then isothermally sintered at 1300 degrees C for 2 h in order to obtain ...