Претраживање
Приказ резултата 1-10 од 12
Application of Iron Manganite Thick Films for Humidity Sensing
(IEEE Computer Society, 2019)
Iron manganite (FeMnO3) thick film samples were obtained by screen printing four layers of thick film paste on alumina substrate with test PdAg electrodes. The paste was made by adding organic vehicles to iron manganite ...
Grain Size and Porosity Dependence of Titanium Dioxide Nano-Paste on Sintering Temperature for Gas Sensing Application
(IEEE Computer Society, 2015)
If the material is being sintered, grain size of its particles will depend on the sintering temperature, time of the sintering and the pressure applied on the material while sintering. It is well known that on the lower ...
Ink-Jet Printed Strain Sensor on Polyimide Substrate
(Proceedings of the International Spring Seminar on Electronics Technology, 2013)
This paper describes a method for measuring strain on a specimen with flexible strain sensor. The sensor is made by ink-jet printing of silver ink on polyimide substrate, in that manner providing a combination of electrical ...
Fully Inkjet Printed CPW Meander Inductors on PET Flexible Substrate
(IEEE Computer Society, 2015)
This paper presents continued research on CPW (coplanar waveguide) meander inductors. The inductors were made in inkjet printing technology. They were printed on polyethylene terephthalate (PET) based substrate (Novele ...
Flexible Inkjet Printed CPW Octagonal Inductor on PET Substrate
(IEEE Computer Society, 2015)
This paper presents fully inkjet printed CPW (coplanar waveguide) octagonal inductor. The inductor was printed with water-based silver nanoparticle ink on flexible polyethylene terephthalate (PET) substrate. The fabricated ...
Impedance Response of Pseudobrookite Thick Films with a Sandwich Configuration
(IEEE Computer Society, 2017)
We have investigated the impedance response of pseudobrookite thick films screen printed on alumina substrate in the temperature interval from room temperature to 350 degrees C in the frequency range 100 Hz - 1 MHz. Two ...
Electrical Properties of Inkjet Printed Graphene Patterns on PET-Based Substrate
(IEEE Computer Society, 2015)
In this paper, electrical properties of inkjet printed graphene patterns on a PET-based (Novele (TM) IJ-220) substrate are presented. Water-soluble graphene conductive ink (Phene plus I3015) was used. Tested samples were ...
Spiral Inductor Fabricated by 3D Additive Manufacturing
(IEEE Computer Society, 2017)
This paper presents spiral inductor fabricated by 3D additive manufacturing. The inductor was made with conductive epoxy silver based paste which was injected in spiral channel fabricated in polylactide (PLA) substrate ...
Design and Simulation of 13.56 MHz RFID Tag in Ink-Jet Printing Technology
(IEEE, 2013)
This paper presents design, modeling and simulation cost-effective RFID (Radio Frequency Identification) tag using ink-jet printing technology. Passive 13.56 MHz RFID tag is based on an inductive-capacitive resonant circuit. ...
Application of Nanocrystalline Pseudobrookite (Fe2TiO5) Thick Films for Humidity Sensing
(IEEE Computer Society, 2018)
Pseudobrookite nanocrystalline thick films were screen printed on alumina substrate with small interdigitated PdAg electrodes (width 6 mm, length 12 mm, electrode spacing 0.2 mm) and fired at 600 degrees C for 30 minutes. ...