Pretraživanje
Prikaz rezultata 1-4 od 4
Parallel analysis of axial pressing, casting and PIM as routes for production of alnico8
(European Powder Metallurgy Association (EPMA), 2010)
Samples of Alnico8 were prepared from the same starting powder by pressing, casting and powder injection moulding (PIM), respectively, and characterized by SEM and thermal analysis-DTA/TGA. Optimization of the sintering ...
Sintered strontium hexaferrite shaped by injection moulding in unidirectional magnetic and electromagnetic field
(European Powder Metallurgy Association (EPMA), 2010)
Strontium hexaferrite permanent magnets were produced by powder injection molding (PIM). The feedstock for powder injection molding was prepared by mixing strontium hexaferrite powder with a "Solvent system" organic binder. ...
Characterization of the structure and magnetic properties of Fe49Co2V made by the powder metal injection molding route
(Advances in Powder Metallurgy and Particulate Materials - 2010, Proceedings of the 2010 Internationa, 2010)
The semi-hard magnetic alloy Fe49Co2V is widely used in electronics and automation. Many of these parts are complex ones which can be produced with significant advantages by the PIM technology. In this work the feedstock ...
Characterization of ferrite surface mount bead using S-parameters
(SIISY 2010 - 8th IEEE International Symposium on Intelligent Systems and Informatics, 2010)
In this paper, characterization of ferrite surface mount bead based on S-parameters measurement, using vector network analyzer E5071B and specially developed PCB test fixture, are presented. The validation of characterization ...