Претраживање
Приказ резултата 141-150 од 152
The alleviation of zinc toxicity by silicon is related to zinc transport and antioxidative reactions in rice
(Springer, Dordrecht, 2011)
The objective of this study is to elucidate the roles of silicon (Si) in enhancing tolerance to excess zinc (Zn) in two contrasting rice (Oryza sativa L.) cultivars: i.e. cv. TY-167 (Zn-resistant) and cv. FYY-326 (Zn-sensitive). ...
Influence of silicon on polymerization process during lignin synthesis. Implications for cell wall properties
(Elsevier B.V., 2022)
Silicon (Si) is considered a beneficial element for plants, mostly accumulating in cell walls, where its location and content are primed by the chemistry and structure of lignin. It is unrevealed how Si interacts with the ...
Nitrate does not result in iron inactivation in the apoplast of sunflower leaves
(Amer Soc Plant Biologists, Rockville, 2003)
It has been hypothesized that nitrate (NO3-) nutrition might induce iron (Fe) deficiency chlorosis by inactivation of Fe in the leaf apoplast (H.U. Kosegarten, B. Hoffmann, K. Mengel [1999] Plant Physiol 121: 1069-1079). ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...
RuxTi1-xO2 as the support for Pt nanoparticles: Electrocatalysis of methanol oxidation
(Amsterdam : Elsevier, 2015)
Two binary Ru-Ti oxides, Rum Ti0.9O2 and Ru0.7Ti0.3O2, were synthesized by the sol-gel method and used as an electrocatalyst support. The system was characterized by XRD, EDS, TEM and cyclic voltammetry. The Rum Ti0.9O2 ...
Investigation on possibility of mechanochemical synthesis of CaTiO3 from different precursors
(Elsevier Sci Ltd, Oxford, 2007)
Recently, mechanochemical synthesis was widely used in preparation of perovskite type of materials, such as BaTiO3, PbTiO3, PZT, etc. In this work, the possibility of mechanochemical synthesis of CaTiO3 from different ...
ZnO varistors from intensively milled powders
(Elsevier Sci Ltd, Oxford, 2007)
Two ways of application of intensive milling in ZnO varistors processing were compared. First was intensive milling of mixture of previously prepared constituent phases. In this case, intensive milling was applied only to ...
Luminescent carbon nanoparticles: effects of chemical functionalization, and evaluation of Ag+ sensing properties
(Royal Soc Chemistry, Cambridge, 2014)
Luminescent carbon-based nanoparticles, addressed as carbon dots (CDs), were synthesized at relatively low temperature from lactose following an easy and inexpensive procedure. Modification of their surface was done by ...
Photosynthesis Enhancement in Maize via Nontoxic Orange Carbon Dots
(Amer Chemical Soc, Washington, 2021)
The sustained increase in leaf photosynthesis may increase crop yield. Due to many limitations, plants use much less photosynthetic capacity than is theoretically possible. Plant nanobionics investigates nanoparticle ...
Interdependence between structure and electrical characteristics in Sm-doped barium titanate
(Elsevier Science Sa, Lausanne, 2017)
Conventional solid-state method was used to prepare powders of pure and barium titanate (BT) doped with different concentration of samarium. Influence of samarium addition on the structure modification, grain growth ...