Pretraživanje
Prikaz rezultata 11-18 od 18
Mechanochemical synthesis of gamma-Bi2O3
(Elsevier, Amsterdam, 2004)
A series of gamma-Bi2O3 phases doped with Zn, Si, Pb and Fe was prepared by mechanochemical treatment of corresponding oxide mixtures with a nominal composition 6Bi(2)O(3) (.) MOx (MOx = ZnO, SiO2, PbO) and 12Bi(2)O(3) (.) ...
Strontium titanate films prepared by spray pyrolysis
(Elsevier Sci Ltd, Oxford, 2004)
Strontium titanate thin films were prepared by spray pyrolysis technique. Deposition parameters, such as solution concentration, time and temperature of deposition, and flow rate of carrier gas were optimized to obtain ...
Changes in sterlet (Acipenser ruthenus L.) catch and length frequency distribution in the Serbian part of the Danube River during the twentieth century
(Polish Academy of Sciences, 2004)
Data from a sample of 262 sterlet (Acipenser ruthenus L.) specimens from the Serbian part of the Danube River were compared with data collected between 1948 and 1967. The recent sample was caught between September 2002 and ...
Photoacoustic properties of sintered NiO
(Walter De Gruyter Gmbh, Berlin, 2004)
The thermal diffusivity of NiO pellets was determined by the photoacoustic technique. A NiO powder, with a purity of 99.95 %, was pressed into pellets 10 mm in diameter. The average agglomerate size of the NiO powder was ...
The nature of structural changes in nanocrystalline ZnO powders under linear heating conditions
(Elsevier Sci Ltd, Oxford, 2004)
The nature of exothermal and irreversible structural changes observed during linear heating of nanocrystalline ZnO powders was investigated using differential scanning calorimetry, X ray, SEM and TEM analysis. Nanocrystalline ...
Nature of structural changes in LSM-YSZ nanocomposite material during thermal treatments
(Elsevier Science Sa, Lausanne, 2004)
Nanocomposite powders in the system (La1-xSx)(a)MnO3-YSZ((1-y)) [LSM-YSZ], as an attractive cathode material for high operating solid oxide fuel cell (SOFC), were obtained through ultrasonic spray pyrolysis (1.7 MHz) method. ...
The influence of mechanical activation on the stoichiometry and defect structure of a sintered ZnO-Cr2O3 system
(Trans Tech Publications Ltd, 2004)
Mixtures of starting ZnO and Cr2O3 powders in equimolar quantities were mechanically activated by grinding using a high energy vibro-mill for 0, 40 and 80 minutes. Qualitative X-ray diffraction analysis made after sintering ...
Evolution of the microstructure of disperse ZnO powders obtained by the freeze-drying method
(Elsevier Science Sa, Lausanne, 2004)
Freeze-drying, as a cryochemical powder processing method is applied in the synthesis of ZnO submicrometer to narrosized powders. The process involves rapid freezing of the sprayed precursor solution, drying under vacuum ...