Приказ основних података о документу

dc.creatorŽunić, Milan
dc.creatorChevallier, Laure
dc.creatordi Bartolomeo, Elisabetta
dc.creatorD'Epifanio, Alessandra
dc.creatorLicoccia, Silvia
dc.creatorTraversa, Enrico
dc.date.accessioned2022-04-05T14:30:54Z
dc.date.available2022-04-05T14:30:54Z
dc.date.issued2011
dc.identifier.issn1615-6846
dc.identifier.urihttp://rimsi.imsi.bg.ac.rs/handle/123456789/486
dc.description.abstractIntermediate temperature solid oxide fuel cells (IT-SOFCs) were fabricated depositing proton conducting BaCe0.9Y0.1O3-x (BCY10) thick films on cermet substrates made of nickel oxide-yttrium doped barium cerate (NiO-BCY10) using electrophoretic deposition (EPD) technique. The influence of the EPD parameters on the microstructure and electrical properties of BCY10 thick films was investigated. Deposited BCY10 thick films together with green anode substrates were co-sintered in a single heating treatment at 1,550 degrees C for 2 h to obtain dense electrolyte and suitably porous anodes. The half-cells were characterised by field emission scanning electron microscopy (FE-SEM) and by X-ray diffraction (XRD) analysis. A composite cathode specifically developed for BCY electrolytes, made of La0.8Sr0.2Co0.8Fe0.2O3(LSCF, mixed oxygen-ion/electronic conductor) and BaCe0.9Yb0.1O3-delta (10YbBC, mixed protonic/electronic conductor), was used. Fuel cells were prepared by slurry coating the composite cathode on the co-sintered half-cells. Fuel cell tests and electrochemical impedance spectroscopy (EIS) were performed in the 550-700 degrees C temperature range. A maximum power density of 296 mW cm(-2) was achieved at 700 degrees C for electrolyte deposited at 60 V for 1 min.en
dc.publisherWiley-V C H Verlag Gmbh, Weinheim
dc.relationMinistry of University and Research (MiUR) of ItalyMinistry of Education, Universities and Research (MIUR)
dc.rightsrestrictedAccess
dc.sourceFuel Cells
dc.subjectSOFCen
dc.subjectEPD Techniqueen
dc.subjectElectrochemical Power Sourcesen
dc.subjectElectrochemical Impedance Spectroscopyen
dc.subjectCeramic Membraneen
dc.titleAnode Supported Protonic Solid Oxide Fuel Cells Fabricated Using Electrophoretic Depositionen
dc.typearticle
dc.rights.licenseARR
dc.citation.epage171
dc.citation.issue2
dc.citation.other11(2): 165-171
dc.citation.rankM21
dc.citation.spage165
dc.citation.volume11
dc.identifier.doi10.1002/fuce.200900104
dc.identifier.scopus2-s2.0-79954512513
dc.identifier.wos000289652400003
dc.type.versionpublishedVersion


Документи

ДатотекеВеличинаФорматПреглед

Уз овај запис нема датотека.

Овај документ се појављује у следећим колекцијама

Приказ основних података о документу