Search
Now showing items 1-10 of 16
Pseudobrookite thick films for potential application as low-temperature sensitive material in NO gas sensors
(IEEE Computer Society, 2017)
Pseudobrookite thick films were obtained by screen printing paste composed of a 1: 1.5 molar ratio mixture of starting nanopowders of hematite and anatase, glass frit and organic binder. The films were deposited on alumina ...
Analysis of electronic properties of pseudobrookite thick films with possible application for NO gas sensing
(IEEE Computer Society, 2016)
Two pseudobrookite (PSB) containing pastes were composed of a mixture of starting nanopowders of hematite (alpha-Fe2O3) and anatase (TiO2) in the molar ratios 1: 1 (referred to as PSB-1) and 1:1.5 (referred to as PSB-1.5), ...
Design and Simulation of 13.56 MHz RFID Tag in Ink-Jet Printing Technology
(IEEE, 2013)
This paper presents design, modeling and simulation cost-effective RFID (Radio Frequency Identification) tag using ink-jet printing technology. Passive 13.56 MHz RFID tag is based on an inductive-capacitive resonant circuit. ...
Fully Inkjet Printed CPW Meander Inductors on PET Flexible Substrate
(IEEE Computer Society, 2015)
This paper presents continued research on CPW (coplanar waveguide) meander inductors. The inductors were made in inkjet printing technology. They were printed on polyethylene terephthalate (PET) based substrate (Novele ...
Grain Size and Porosity Dependence of Titanium Dioxide Nano-Paste on Sintering Temperature for Gas Sensing Application
(IEEE Computer Society, 2015)
If the material is being sintered, grain size of its particles will depend on the sintering temperature, time of the sintering and the pressure applied on the material while sintering. It is well known that on the lower ...
Flexible Inkjet Printed CPW Octagonal Inductor on PET Substrate
(IEEE Computer Society, 2015)
This paper presents fully inkjet printed CPW (coplanar waveguide) octagonal inductor. The inductor was printed with water-based silver nanoparticle ink on flexible polyethylene terephthalate (PET) substrate. The fabricated ...
Investigation of Dielectric Properties of Printed Material for Capacitor Application
(IEEE Computer Society, 2020)
This paper investigates the dielectric characteristics of the material used to make capacitor in fused filament fabrication technology. The characteristics of the capacitor made of PLA (Polylactic Acid) as dielectric are ...
Application of Iron Manganite Thick Films for Humidity Sensing
(IEEE Computer Society, 2019)
Iron manganite (FeMnO3) thick film samples were obtained by screen printing four layers of thick film paste on alumina substrate with test PdAg electrodes. The paste was made by adding organic vehicles to iron manganite ...
Design and Modelling of 3D Printed Capacitive Displacement Sensor
(IEEE Computer Society, 2021)
The aim of the work is the realization and modelling of a simple capacitive displacement sensor with the use of 3D printing technology and polylactic acid (PLA) material. The sensor consists of three 3D printed PLA parts: ...
Impedance Response of Pseudobrookite Thick Films with a Sandwich Configuration
(IEEE Computer Society, 2017)
We have investigated the impedance response of pseudobrookite thick films screen printed on alumina substrate in the temperature interval from room temperature to 350 degrees C in the frequency range 100 Hz - 1 MHz. Two ...