Претраживање
Приказ резултата 1-10 од 31
Chemical stability and electrical properties of Nb doped BaCe0.9Y0.1O3-delta as a high temperature proton conducting electrolyte for IT-SOFC
(Elsevier Sci Ltd, Oxford, 2013)
BaCe0.9-xNbxY0.1O3-delta (where x=0, 0.01, 0.03 and 0.05) powders were synthesized by solid-state reaction to investigate the influence of Nb concentration on chemical stability and electrical properties of the sintered ...
Improvement of barium titanate properties induced by attrition milling
(Elsevier Sci Ltd, Oxford, 2012)
Barium titanate powder was prepared by soft chemical process from polymeric precursors (modified Pechini process). The synthesized barium titanate (BT) powder was nanosized and the factor of agglomeration (F-agg) pointed ...
Enhanced stability in CO2 of Ta doped BaCe0.9Y0.1O3-delta electrolyte for intermediate temperature SOFCs
(Elsevier Sci Ltd, Oxford, 2013)
The influence of Ta concentration on the stability of BaCe(0.9-)xTa(x)Y(0.1)O(3-delta) (where x=0.01, 0.03 and 0.05) powders and sintered samples in CO2, their microstructure and electrical properties were investigated. ...
Physical-mechanical and microstructural properties of alkali-activated fly ash-blast furnace slag blends
(Elsevier Sci Ltd, Oxford, 2015)
This paper investigated physical mechanical and microstructural properties of alkali-activated binders based on blends of fly ash (FA) and blast furnace slag (BFS). FA BFS blends were alkali-activated with sodium silicate ...
Lead immobilization by geopolymers based on mechanically activated fly ash
(Elsevier Sci Ltd, Oxford, 2014)
In this paper, the effectiveness of geopolymers based on initial and mechanically activated fly ash in immobilization of lead was investigated. Fly ash (FA) was firstly mechanically and then alkali activated at room ...
Ex-situ sensitization of ordered TiO2 nanotubes with CdS quantum dots
(Elsevier Sci Ltd, Oxford, 2015)
Ordered titania nanotubes (pore diameter approximate to 90 nm and wall thickness approximate to 10 nm) were obtained by the anodization technique and used for the ex-situ deposition of cadmium sulfide quantum dots (CdS ...
Hydrothermally assisted synthesis of YMnO3
(Elsevier Sci Ltd, Oxford, 2015)
In this work single phase hexagonal YMnO3 powders were prepared starting from Y(CH3COO)(3)center dot xH(2)O, Mn(CH3COO)(2)center dot 4H(2)O, KMnO4 and KOH using methods of conventional (280 degrees C for 6 h) or microwave ...
Structural, electrical and magnetic properties of nickel manganite obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2014)
Structural, electrical and magnetic properties of nickel manganite ceramics obtained by sintering fine powders prepared by a complex polymerization method are given in this work. The phase composition of the synthesized ...
Morphology investigation of mechanically activated ZnO-SnO2 system
(Elsevier Sci Ltd, Oxford, 2008)
Powder mixtures of zinc oxide and tin oxide in the molar ratio, ZnO:SnO2 = 2: 1, were mechanically activated in a planetary ball mill in the time intervals of 0-160 min. The adsorption-desorption isotherms, specific surface ...
Comparative study of CeO2 nanopowders obtained by the hydrothermal method from various precursors
(Elsevier Sci Ltd, Oxford, 2015)
The effects of common precursors used in the synthesis of CeO2 nanopowders were investigated, and the structural and spectral properties of the resulting products were compared. Two cerium (III) salts, i.e., Ce(NO3)(3)center ...